Using a single command structure, Set-up the structure in memory, Clear 52 bytes of system memory at the location – Ciprico Rimfire 3880 User Manual

Page 69: Build a parameter block in bytes 0 through 28, Assign a value to the interrupt field of the si, Prepare the hardware ports, If you are going to use this command to set bus, Write the control field, address modifier and t, Read the status port. test the rdy bit (bit 1), Execute the command

Advertising
Using a single command structure, Set-up the structure in memory, Clear 52 bytes of system memory at the location | Build a parameter block in bytes 0 through 28, Assign a value to the interrupt field of the si, Prepare the hardware ports, If you are going to use this command to set bus, Write the control field, address modifier and t, Read the status port. test the rdy bit (bit 1), Execute the command | Ciprico Rimfire 3880 User Manual | Page 69 / 230 Using a single command structure, Set-up the structure in memory, Clear 52 bytes of system memory at the location | Build a parameter block in bytes 0 through 28, Assign a value to the interrupt field of the si, Prepare the hardware ports, If you are going to use this command to set bus, Write the control field, address modifier and t, Read the status port. test the rdy bit (bit 1), Execute the command | Ciprico Rimfire 3880 User Manual | Page 69 / 230
Advertising
See also other documents in the category Ciprico Hardware: