Ciprico Rimfire 3880 - Manual (Page 97)

User’s Guide 21020285 D
Chapter 5 Initiator Mode Pass-through Commands
Initiator Pass-through Status Block Format Page 5 - 13
CSB Continued Status Block - This bit indicates that the current Status
Block is one of several Status Blocks generated because extended Sense Bytes
are enabled. Only valid for Pass-through commands issued through Command
List.
0
⇒
Status Block is first (or only) Status Block
1
⇒
Status Block is one of a series of Status Blocks.
DTG Data Transfer Greater - Indicates when an Initiator Pass-through
command completes with more bytes requested by the SCSI device than was
specified in the Transfer Count field.
0
⇒
Data transfer was not greater.
1
⇒
Data transfer was greater.
DTT Data Transfer Truncated - Indicates when an Initiator Pass-through
command completes with fewer bytes transferred than requested in the Transfer
Count field.
0
⇒
Data transfer was not truncated.
1
⇒
Data transfer was truncated.
RTY Retry - Indicates whether an Initiator Pass-through command required
retries to complete.
0
⇒
No retries were required.
1
⇒
Retries were required to complete.
ERR Error Status - Identifies when a command, Board-control or Pass-
through, completes with an error.
0
⇒
No error occurred.
1
⇒
An error occurred.
CC Command Complete - Indicates whether a command has finished.
0
⇒
Command not complete.
1
⇒
Command complete.
Error
When an adapter-detected error occurs, this byte contains an error code to
describe the condition. See Appendix A.