Table 94: option flags field - identify status blo, Table 95: adapter scsi id bits – Ciprico Rimfire 3880 User Manual
Page 160
21020285 D
User’s Guide
Chapter 7 Board-control Commands
Page 7 - 36
Board Information (15H)
Option Flags
The Options Flags byte returned here is identical to the byte returned with the
Identify command. It is used to indicate whether a particular option is enabled
or available in the revision of firmware installed.
The bit-meanings of the Option Flags field are as follows:
RST Reset Jumper
0
⇒
SCSI bus will not be reset.
1
⇒
SCSI bus will be reset.
SCSI ID BITS SCSI ID of Adapter
- Indicates the current ID of the adapter.
0
⇒
Bit of ID not set.
1
⇒
Bit of ID set.
Firmware Number of Even EPROM
There is a set of two EPROMs on the board. This number is the Firmware
Number of the EVEN EPROM.
BITS
7
6
5
4
3
2
1
0
SCSI ID 2 SCSI ID 1 SCSI ID 0
RST
0
0
SCSI ID3
Table 94: Option Flags Field - Identify Status Block
SCSI ID
Option Flags Bits
0
7
6
5
0
0
0
0
0
1
0
0
0
1
2
0
0
1
0
3
0
0
1
1
4
0
1
0
0
5
0
1
0
1
6
0
1
1
0
7
0
1
1
1
8
1
0
0
0
9
1
0
0
1
10
1
0
1
0
11
1
0
1
1
12
1
1
0
0
13
1
1
0
1
14
1
1
1
0
15
1
1
1
1
Table 95: Adapter SCSI ID Bits