Magnum Dynalab MD-109 - Manual (Page 10)

PROGRAMMING THE TOUCH SCREEN
The touch screen is designed to last 10,000 hours. Once the unit has been
turned on and the touch screen has been activated it will be at full brightness.
After two minutes of inactivity (no touching) the screen will go into a sleep mode,
this sleep mode (50 % brightness) will lengthen the life of the screen. To activate
the screen touch any point on the Magnum Dynalab logo, use the remote hand
held or turn the right hand knob (tuning dial).
Cleaning the touch screen: Only use a very soft cloth (eyeglass cleaning cloth) with
a non-abrasive cleaner.
SETTING THE FM PRESETS FROM THE TOUCH SCREEN
1. With the screen displaying the FM frequency, touch the digits, a new screen
will appear depicting the preset grid.
STEREO BAND BLEND DIM MUTE POWER
99.1
STEREO
SUPER NARROW
BLEND
MUTE
PRESET 03
MHz
MONO
NARROW / WIDE
Extra Text
PRE
1 2 3
4 5 6
7 8 9
S 0 P
FM TUNER
2. Tune to the station you wish to store, push the “S” button on the display and
then the preset location, you must use two numbers i.e.: 01. You must also
do this fairly quickly to insure storage. Repeat this procedure for up to 40
preset locations.
3. To scan the presets, push the button showing “MHz”, it will change to “ pre” if
you push the up arrow above it you will scan your presets going up, by pushing
the down button you will view the ones below. To return to “MHz”, push the “
pre” button.
4. To return to the main screen touch any point on the screen.
- 10 -