Nexen H-1000 810080 - Manual (Page 12)

12 FORM NO. L-20143-J-1209
Refer to Figures 11 & 12.
26. Remove the six Flat Head Screws (Item 5) and the old
Friction Facing (Item 4) from the Sheave or Drive Disc
(Item 1).
27. Using six new Flat Head Screws (Item 5), secure the
new Friction Facing (Item 4) to the Sheave or Drive
Disc (Item 1).
28. Alternately and evenly tighten the six Flat Head Screws
(Item 5) to the recommended torque (See Table 7).
29. Apply a thin film of Never-Seez ® to evenly coat the
splines of the Hub (Item 6).
30. Slide the Compression Spring (Item 7) onto the Hub
(Item 6).
31. Slide the Cylinder, Piston, and Friction Disc, and
Adjustment Nut (Item 16) onto the Hub (Item 6).
32. Screw the Adjustment Nut (Item 16) onto the Hub (Item
6).
33. Check Friction Facing adjustment (See FRICTION
FACING ADJUSTMENT).
TABLe 7
L E D O M . O N M E T I N O I T P I R C S E D E U Q R O T
0 5 4 - F
D T S 5
R T M 5
4 2 - 0 9 1 .
8 . 0 - 5 M
. s b L . n I 6 2
m N 9 . 2
0 0 6 - L
D T S 5
R T M 5
4 2 - 0 9 1 .
8 . 0 - 5 M
. s b L . n I 6 2
m N 9 . 2
0 0 8 - M
D T S 5
R T M 5
0 2 - 0 5 2 .
0 . 1 - 6 M
. s b L . n I 6 8
m N 7 . 9
0 0 0 1 - H
D T S 5
R T M 5
0 2 - 0 5 2 .
0 . 1 - 6 M
. s b L . n I 6 8
m N 7 . 9
PArTS rePLACeMenT (continued)
FIGure 11
1
4
5
FIGure 12
6
7
Apply a thin film
of Never-Seez
® .
17
16
Cylinder, Piston,
and Friction Disc