Nexen H-1000 810080 - Manual (Page 6)

6 FORM NO. L-20143-J-1209
2. Attach the Adapter Plate (Item 24) to the Air Champ II,
using Cap Screws (Item 33) and Lock Washers (Item
34).
3. Tighten the Cap Screws (Item 33) to the recommended
torque (See Table 4).
4. Slide the Air Champ II complete with the Coupling
Adapter Plate onto the Driving Shaft until the Coupling
Adapter Plate is flush with the end of the Driving
Shaft.
5. Insert the Key (Item 19) into the Driving Shaft
keyway.
6. Tighten the Set Screws (Item 18) to the recommended
torque (See Table 2).
7. Place the Flexible Ring (Item 25) over the pins of the
Adapter Plate (Item 24).
8. Insert the customer supplied Dodge Taper-Lock ®
bushing into the Coupling Hub (Item 26).
9. Align the holes, not the threads, and slide the Dodge
Taper-Lock ® bushing onto the Driven Shaft until it is
flush with the shaft.
10. Thread the screws supplied with the Dodge Taper-
Lock ® bushing into the threaded holes of the Coupling
Hub (Item 26); then, alternately and evenly tighten the
screws to the bushing manufacturer’s specifications.
11. Align the pins in the Coupling Hub (Item 26) with the
holes in the Flexible Ring (Item 25) and push the entire
assembly together.
NOTE: Automatic spacing is accomplished by a spacer
molded into the Flexible Ring (Item 25).
12. Secure the Driven Shaft.
TABLe 4
FIGure 3
L E D O M . O N M E T I N O I T P I R C S E D E U Q R O T
0 5 4 - F 5 2 0 2 - 0 5 2 . ] m N 0 5 . 8 2 [ . s b L .t F 1 2
0 0 6 - L 5 2 0 2 - 0 5 2 . ] m N 0 5 . 8 2 [ . s b L .t F 1 2
0 0 8 - M 5 2 8 1 - 2 1 3 . ] m N 8 1 . 1 3 [ . s b L .t F 3 2
0 0 0 1 - H 5 2 6 1 - 5 7 3 . ] m N 5 7 . 5 0 1 [ . s b L .t F 8 7
24
25
26
34
33
19
18
Driving Shaft
Driven
Shaft
Dodge Taper-Lock ®
Bushing
Air Champ II
FIGure 2
InSTALLATIOn (continued)