Petsafe 250 m Remote Trainer - Manual (Page 11)

www.petsafe.net 11
Program the Remote Transmitter
Note: The Transmitter is factory set to Mode 1. The Mode of the Remote Transmitter can be
changed to fi t your type or style of training.
To change the Mode:
1. Referring to the table below, adjust the Intensity Dial to
the Mode you want to use.
2. Turn the Remote Transmitter over.
3. With a pen or paperclip, depress and release the
Mode button. When the Mode button is pressed, the
Transmitter Indicator Light will be solid red. When it is
released, it will fl ash the Mode selected.
For example, if Mode 2 is desired, adjust the Intensity Dial to Level 2. Once the Mode
button has been depressed, the Transmitter Indicator Light will be solid red and once the
Mode button is released, the Transmitter Indicator Light will fl ash two times.
Note: Continuous Stimulation will transmit for no more than eight continuous seconds no matter
how long the button is pressed. To reactivate, release and repress the button.
Mode UPPER BUTTON
FUNCTION
LOWER BUTTON
FUNCTION
SIDE BUTTON
FUNCTION
# OF
DOGS
1 Tone 1 Second then
Continuous Stimulation
set by Dial
Tone 1 Second then
Continuous Stimulation
2 levels higher than
Intensity Dial setting
Tone only 1
2 Tone 1 Second then
Continuous Stimulation
set by Dial
Continuous Stimulation
set by Dial
Tone only 1
3 DOG #1
Tone only
DOG #2
Tone only
DOG #3
Tone only
3
4 DOG #1
Tone 1 Second then
Continuous Stimulation
set by Dial
DOG #2
Tone 1 Second then
Continuous Stimulation
set by Dial
DOG # 3
Tone 1 Second then
Continuous Stimulation
set by Dial
3
Step
5
400-1158-19.indd 11 400-1158-19.indd 11 9/25/09 10:41:05 AM 9/25/09 10:41:05 AM