Petsafe 250 m Remote Trainer - Manual (Page 7)

www.petsafe.net 7
Prepare the Receiver Collar
Charge the Receiver Collar
1. Lift the rubber cover protecting the Receiver Collar
Charging Jack.
2. Connect one of the charger connectors to the
Receiver Collar Charging Jack (2A).
3. Plug the charger into a standard wall outlet. The
red light will appear.
4. Charge the Receiver Collar for 24 hours for the
fi rst charge. Recharges take only 12 hours.
Note: The Receiver Indicator Light is solid green after
12 hours of charging. For the fi rst charge, continue to
charge the Receiver Collar for an additional 12 hours.
5. When charging is completed, replace the rubber
cover.
Charger connector
placed in Receiver
Collar Charging
Jack
2A
To Turn the Receiver Collar On:
1. Press and hold the On/Off Button (2B) until the
Receiver Indicator Light comes on solid green
and you hear the Receiver Collar beep from low
to high.
2. Release the On/Off Button.
The Receiver Indicator Light fl ashes green once
every 5 seconds to indicate the battery is good.
This fl ashing green light also indicates the Receiver
Collar is on and ready to receive a radio signal
from the Remote Transmitter.
Note: If the Receiver Indicator Light fl ashes red 3
times every 5 seconds (instead of green), this indicates
that the battery charge is low and the unit should be
recharged before use.
On/Off Button 2B
To Turn the Receiver Collar Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on solid
red and the Receiver Collar beeps high to low.
2. Release the On/Off Button.
To extend the life between charging cycles, turn the Receiver Collar off when it is not in
use. Approximate battery life between charges is 15-20 hours, depending on frequency of
use.
Step
2
400-1158-19.indd 7 400-1158-19.indd 7 9/25/09 10:41:04 AM 9/25/09 10:41:04 AM