Petsafe Big Dog Remote Trainer - Manual (Page 16)

16 www.petsafe.net
FR
EN
ES
NL
IT
DE
Do not shave the pet’s neck as this may increase
the risk of skin irritation.
4. Check the tightness of the Receiver Collar by inserting one
fi nger between the collar and your dog’s neck (3C). The fi t
should be snug but not constricting.
You should not make the collar any more tight
than is required for good contact. A collar that
is too tight will increase the risk of pressure
necrosis in the contact area.
5. Allow your dog to wear the Receiver Collar for several minutes
then recheck the fi t. Check the fi t again as your dog becomes
more comfortable with the Receiver Collar.
6. Trim the collar as
follows (3D):
a. Mark the desired length
of the collar with a pen.
Allow for growth if your
pet is young or grows a
thick winter coat.
b. Remove the Receiver
Collar from your pet
and cut off the excess.
Important: Do not cut the part of the collar containing the
Antenna on the Little Dog Remote Trainer.
c. Before placing the Receiver Collar back onto your pet, seal
the edge of the cut collar by applying a fl ame along the
frayed edge.
Care and Cleaning
• Your dog’s neck and the Contact Points must be washed weekly
with a damp cloth.
• Be sure that your pet’s neck is thoroughly dry before placing the
Receiver Collar back on his neck.
3D