Petsafe Drinkwell® Ceramic Lotus Pet Fountain - Manual (Page 3)

5 4
FOUNTAIN: CLEAN ONCE A WEEK
FOUNTAIN DISASSEMBLY & CLEANING
Unplug the fountain and disconnect the inline plug. (See Fig. 7)
Next, remove the upper dish and set aside. (See Fig. 8)
Remove the entire housing by lifting straight up and set aside. Empty
all of the water out of the fountain.
1)
2)
3)
With the housing removed and the fountain completely empty, turn
the bowl over to loosen and remove the nut on the bottom of the
bowl. (See Fig. 9)
Next, remove the intake tube from the pump by lifting straight up.
Grab the Cord Pass-Thru Tube and lift up to expose the hole in the
bottom of the bowl. Pull the electrical cord through the opening until
completely removed.
Once the electrical cord has been removed from the bowl, continue
pulling the cord through the Cord Pass-Thru Tube. (See Fig. 10)
4)
5)
6)
6)
The Fountain must be cleaned on a regular basis to
continue working normally!
With the housing in place, affix the housing cap by aligning the
arrow on the cap with the picture of a lock on the housing (See
Fig. 5). With these two items aligned, press down on the cap while
simultaneously turning it to the right, this will secure the cap.
Fig. 4b Fig. 4a
7)
8)
9)
10)
11)
12)
Place the O-ring over the housing. (See Fig. 6) Next, slide the upper
dish onto the housing. Rotate the upper dish until you are happy with
how the spouts line up with the bottom bowl.
Adjust the flow of water by turning the housing cap in between the
two arrows marked on the side of the housing. The arrow shown with
a “+” sign beneath it indicates maximum flow.
Place the fountain in a desired location. If placing on carpet, tile or
wood flooring, always use a protective mat or other durable, water
resistant surface to help protect your floor from splashing or dripping.
Fill the fountain with water by pouring water directly into the bottom
bowl and upper dish. Fill the fountain with water to the MAX Fill Line.
Before you plug the fountain in, make sure the cord and your hands
are dry. Plug the fountain into an electrical outlet.
Add water to the fountain as needed. Never let the water level fall
below the MIN Fill Line or you may risk burning out the pump.
Fig. 6 Fig. 5
Fig. 7 Fig. 8
Fig. 9 Fig. 10