Petsafe Drinkwell® Original Pet Fountain - Manual (Page 10)

www.petsafe.net 11 10 www.petsafe.net
EN
ES
FR
IT
NL
DE
5. Once the Pump is disassembled you can clean the parts with warm water and soap.
Use a cotton swab or the “motor” brush from the Drinkwell ® Cleaning Kit to get into
the Pump’s motor cavity and remove any build-up ( Fig. 11). For added disinfecting
and hard water removal, clean the Pump’s motor with a diluted vinegar solution (20%
White Vinegar and 80% Water). Be sure to rinse thoroughly with fresh water.
6. Once the parts are clean you can reassemble the
Pump for use.
a) Replace the Impeller.
b) Replace the Intake Plate.
c) Replace the Faceplate with the Flow
Control Knob attached to it.
pet Fountain reassembly
1. Replace the Pump by aligning the unit into its fitted space
inside the Bowl ( Fig. 12). The suction cups on the Pump
should be facing down and the Flow Control Knob facing into
the Bowl. Gently push down to engage suction cups.
2. Thread the In-Line Plug of the electrical Power Cord through
the hole located next to Pump and push the rubber gasket
firmly into the hole. To insure the Pet Fountain Bowl is stable,
run the electrical Power Cord along the “cord channel” and
through the notch in the base of the Pet Fountain (
Fig. 13).
3. Attach the Housing by sliding the cutout in the wall of the
Housing down over the Flow Control Knob. The Housing will
click into place when the side tabs are inserted in the Bowl
(
Fig. 14).
4. Replace the Charcoal Filter, with the black side facing the front
of the Pet Fountain towards the spout.
5. Fill the Bowl with water and replace the Housing Lid.
6. Place Pet Fountain in desired location. Do not pick up a full
Pet Fountain by the Housing. Only pick up the Pet Fountain by
placing both hands underneath the base of the Pet Fountain
and grip the sidewalls for a sturdy hold.
Important: To
protect your floor always use a protective mat such as a towel
or water-resistant placemat. This will help protect your floor
from any splashing or spills caused by your pet.
7. Before you plug in the Pet Fountain make sure the electrical
Power Cord, the plug and your hands are dry. Connect the In-Line Plug and makes
sure no silver is showing then plug the adaptor into a standard electrical wall outlet.
Fig. 11
Fig. 12
Fig. 13
Fig. 14