Petsafe Drinkwell® Original Pet Fountain - Manual (Page 7)

www.petsafe.net 7
FR
IT
NL
DE
EN
ES
operating Instructions
Important: DO NOT RUN DRY - FOR INDOOR USE ONLY. Pet Fountain will come
fully assembled and ready for use.
1. As with any electrical device, check the electrical Power Cord
for any tears or damage before use.
2. Make sure the In-Line Plug is connected. When connected
properly the silver tip is not showing.
3. Remove the Housing by pressing the side tabs and lifting up.
Inspect the inside of the Pet Fountain to ensure Pump is securely
attached (
Fig. 1). Snap Housing back into place.
4. Remove the Housing Lid and set aside.
5. Insert the Charcoal Filter. The Charcoal Filter fits diagonally into the two triangular slots
located inside the Housing. The Charcoal Filter fits narrow side down, with the black
side facing the front of the Pet Fountain towards the spout. The Charcoal Filter will slide
easily into place, but make sure it is pushed all the way down (
Fig. 2 & 3).
Important: Rinse the Charcoal Filter thoroughly under cool water before placing in the
Pet Fountain. This will remove any loose charcoal dust, which is harmless. A small amount
of charcoal dust may be released for the life of the Charcoal Filter. This is normal and is
not harmful to your pet.
6. Fill the Bowl with water. Replace the Housing Lid.
7. Place the Pet Fountain in desired location. Do not pick up a full Pet Fountain by the
Housing. Only pick up the Pet Fountain by placing both hands underneath the base of
the Pet Fountain and grip the sidewalls for a sturdy hold.
Important: To protect your
floor always use a protective mat such as a towel or water-resistant placement. This will
help protect your floor from any splashing or spills caused by your pet.
8. Before you plug in the Pet Fountain, make sure the electrical Power Cord, the plug,
and your hands are dry. Plug the Pet Fountain into a standard electrical wall outlet.
9. Set your desired flow rate with the Flow Control Knob, which is located to the right of
the receiving ramp inside the Bowl. When the Flow Control Knob is in the 10 o’clock
position, flow is at its lowest. When the Flow Control Knob is in the 2 o’clock position,
flow is at its highest.
10. Add water to the Bowl as needed. Do not let the water level fall below the Flow
Control Knob or you may risk Pump failure. Replacement Pumps are sold separately
by contacting the Customer Care Centre. Visit www.petsafe.net for a telephone listing
of the Customer Care Centre near you.
pump
Fig. 1
Fig. 2
Charcoal
Filter
Fig. 3