Petsafe Drinkwell® Outdoor Dog Fountain - Manual (Page 11)

www.petsafe.net 11
FOUNTAIN REASSEMBLY
Check the flow control dial make sure the dial is positioned at the
desired flow rate. When the yellow tab is closest to the “+” sign,
the pump is set at maximum flow. When the yellow tab is closest to
the “-” sign, the pump is set at its lowest flow (see images below). 1)
MAX FLOW MIN FLOW
Replace the pump between the two posts on the bottom of the
bowl with the suction cups face down. Feed the electrical cord
through the opening on the inside of the bowl. Insert the two
prongs into the adaptor and re-thread the plastic locking collar
onto the adaptor, until no threads show. See Figures 12a & 12b. 2)
Fig. 12a Fig. 12b
Feed the cord underneath the bowl and out the backside through
the cord notch. Do not plug the fountain into electricity until the
fountain is filled with water and your hands are dry.
With the pump in place and suctioned to the bowl, replace the
foam filter in its original position. See Page 5 of this operating
guide for exact placement.
3)
4)
Fig. 13 Next, connect the T-Tube and the
Outflow Tube together. With the
pieces connected, affix the T-Tube to
the bottom of the housing as shown
in Figure 13. Make sure the T-Tube is
pressed all the way down, so that the
little notch clips into the holder on the
bottom of the housing. 5)