Petsafe Drinkwell® Outdoor Dog Fountain - Manual (Page 5)

www.petsafe.net 5
DO NOT RUN DRY
INDOOR HOUSEHOLD USE OR SEASONAL OUTDOOR USE
OPERATING INSTRUCTIONS
1)
2)
As with any electrical device, check the electrical cord for any
tears, or damage before use.
Make sure the low-voltage power adaptor is tightly connected to
the pump’s electrical cord and that the threaded locking collar is
tightened completely, see Figures 1a & 1b.
Fountain will come fully assembled and ready for use. Rinse fountain and reservoirs before using.
Installing the Charcoal Filter:
Open the housing lid to place the charcoal filter (one
filter is included with your fountain). The Charcoal
Filter fits between the grooves in the housing with the
black side facing out towards the bowl, as shown in
Figure 2. Make sure the filter is pushed all the way
down and close the lid.
Installing the Foam Filter:
The foam filter will come installed around the pump
beneath the housing, as shown in Figure 3. You will
be able to see the foam filter in place by looking
through the pre-filter on the right side.
IMPORTANT: Rinse charcoal filter thoroughly under cool water before placing in the housing. This
will remove any loose charcoal dust, which is harmless. A small amount of charcoal dust may shed
for the life of the filter. This is normal and not harmful to your pet.
Fig. 3
Fig. 2
Your fountain comes equipped with two different filters, a charcoal
filter that removes bad tastes and odors and a foam filter to trap
larger debris before it reaches the pump. 3)
Fig. 1a Fig. 1b