Petsafe Drinkwell® Zen Fountain - Manual (Page 4)

4
OPERATING INSTRUCTIONS
5) Make sure the pump is inside the bowl’s square indention and
positioned with the pump tube in the back left corner. Gently press
down on the tube to ensure it is secured to the pump (Fig. 4).
6) Replace the housing by lowering straight down over the pump. Be
sure the housing connects with the guide holes on the rim of the
bowl. Push down to lock it in place (Fig. 5).
7) Place the fountain in a desired location. If placing on carpet,
tile or wood flooring, use a protective mat or other durable,
water resistant surface. This will help protect your floor from any
splashing or spills caused by your pet.
8) Fill the fountain by pouring water directly into the bowl. We
recommend leaving at least a 1/2” (1.27 cm) of space between the
water level and the rim of the bowl.
9) Before you plug in the fountain, make sure the cord, the adaptor and
your hands are completely dry. Plug the fountain into an electrical outlet.
10) Add water to the fountain as needed. Never let the water level fall
below the MIN water line marked on the housing or you may risk
burning out the pump. Replacement pumps are sold separately.
Fig. 4
NOTE: If your fountain’s stream appears to not be flowing correctly and
has gaps within the stream, please take the following steps:
a) Remove the top piece of the spout and reassemble; OR
b) Run a fingernail or other slim object in between the spout pieces
to make sure there are no blockages; OR
c) Dump out the water and clean your pump to ensure build-up is
not affecting the flow of your fountain’s stream.
Fig. 5