Petsafe Innotek Remote Backing Dog Manual & Automatic Launchers - Manual

Step 1
Power Up
Premium Tracking System
Quick Start Guide
RD-400
Collar Transmitter: Insert 3v lithium battery in the transmit-
ter positive (+) side out. Replace battery cap.
Handheld Receiver: Insert 9v alkaline battery into the battery clip.
Collar transmitter: Hold the keychain magnet against the red dot located on the
antenna-side of the transmitter. The LED will illuminate green; remove the key-
chain magnet. The LED will glow GREEN for one second, then flash YELLOW for
each channel count. The LED will return to flashing GREEN, indicating that the
unit is transmitting a signal.
OFF: Hold the keychain magnet against the red dot. The LED will flash RED for
one second, then shut down.
Handheld Receiver: Press the RED button on the upper left side of the meter to
turn ON; press and hold the RED button for 2 seconds; the receiver will turn OFF.
When the receiver is turned ON, the LCD display shows the current channel set-
ting. Press and release the RED button to change band setting; press and release
the BLACK button to change channel selection. (The receiver will automatically
return to the band and channel at which it was last set when turned OFF.) Channel
setting on the collar transmitter must be the same as set on the receiver.
Proper Fit: The collar fit should be snug, yet loose enough
to allow one finger to fit between the strap and the dog’s
neck. Fit is important because a loose collar may rotate
round the neck, causing inconsistent performance. It’s
okay to trim any excess strap length.
Step 2
Turn components ON/OFF
Step 3
Band and Channel Selection
1.
Step 4
Adjust the collar