Petsafe Innotek Remote Backing Dog Manual & Automatic Launchers - Manual (Page 3)

indicated and transmission strength is reduced. Replace the battery
immediately.
Battery
The transmitter uses a 3-volt lithium battery. It can produce a life of up
to 70 hours. Battery life will be less during use at lower temperatures.
Understanding the Receiver
The handheld receiver monitors for up to 16 signals. The receiver is
water-resistant and should not be immersed in water.
Controls:
1. ON/OFF/Band Selection: Press the RED button on the upper left of
the control panel.
2. LCD: Indicates the status of the receiver
3. Channel Selection/Backlight: Press the BLACK button on the upper
right side of the control panel to select a channel. For easier nighttime
viewing, press and HOLD the BLACK button until the backlight comes
on. Press and HOLD again to turn it off (Using the backlight feature
will reduce the receiver’s battery life).
4. Tuning Control: Turn the knob marked with RED on the unit’s left
side. This control provides fine-tuning of the received signal. Rotate
dial to tune out static; the goal is to get a clear tone with high pitch.
The knob pointer will usually point straight UP to get the channel
tuned.
5. Gain Control: Turn the knob marked with WHITE on the unit’s right
side. It controls meter deflection and the volume of the received signal.
6. Meter: Indicates signal strength
On/Off/Band Selection Channel Selection/Backlight
Gain
Control
Round red dot on side indicates magnet which may be used
to turn the collar-transmitter ON and OFF.
Tuning
control
3.
Meter