Petsafe Innotek Remote Backing Dog Manual & Automatic Launchers - Manual (Page 5)

age to the antenna elements, always insert the antenna shaft into the
case as centered as possible.
Replacing Receiver Antenna Elements
Your Premium Tracking System comes with a spare set of antenna
blades (3 for the receiver; 1 for the collar transmitter). Before replacing
an antenna blade, first remove the protective latex coating, which cov-
ers the end to be inserted. You may scratch/peel this
coating off with your fingers or a dull instrument to
expose the bare blade. Removing this coating is
necessary to maintain the system’s performance.
Loosen the blade retaining screw with an Allen wrench and pull the
antenna element out. Insert the tab end of the new element into the
slot so the tab is fully seated. Tighten the remaining screw with an
Allen wrench. Do not over tighten. IMPORTANT: Never completely
remove the retaining screw.
Note:
1. Shortest element goes in the position farthest from the handle.
2. Mid-length element goes in the middle position.
3. Longest element goes in the position closest to the handle.
The convex (curved out) side of each element faces forward.
Replacing Collar Transmitter Antenna Element
Follow illustration below:
Collar Transmitter Antenna
Replacement
1. Remove plastic cap screws
2. Remove hex nuts with 1/2” socket
head screwdriver
3. Remove cover plate
4. Remove collar
5. Remove washer
6. Remove antenna
7. Reverse the above
steps to reassemble
1.
1.
2.
2.
3.
4.
5.
6.
5.
1.
2.
3.
FORWARD
Protective Coating