Petsafe Pawz Away® Mini Pet Barrier - Manual (Page 10)

10 Customer Care Center 1-800-732-2677
4. Adjust the tightness of the Receiver Collar to fit your pet’s neck. Check the
tightness of the Receiver Collar by inserting one finger between the end of a
Contact Point and your pet’s neck. The fit should be snug but not constricting
(4B).
5. Allow your pet to wear the Receiver Collar for several minutes then recheck
the fit. Check the fit again as your pet becomes more comfortable with the
Receiver Collar.
6. Once you are satisfied with the fit of the Receiver Collar then you may trim
any excess collar strap as follows (4C):
a. Mark the desired length of the Receiver Collar with a pen. Allow for growth if
your pet is young or grows a thick winter coat.
b. Remove the Receiver Collar from your pet and cut off the excess.
c. Before placing the Receiver Collar back onto your pet, seal the edge of the
cut collar by applying a flame along the frayed edge.
4B
4C
To Re-Thread the Collar
Slide Buckle
Ridges
The slide buckle prevents the collar from becoming loose around your pet’s neck.
The ridges must be facing up; the collar will slip if it is not properly threaded.