Programming the mode settings – Petsafe Pawz Away® Mini Pet Barrier User Manual
Page 14
14
Customer Care Center 1-800-732-2677
Programming the Mode Settings
All programming is done through the Barrier Transmitter and the programming is synchronized with the Receiver
Collar. The Receiver Collar cannot be programmed separately from the Barrier Transmitter.
You may synchronize multiple Receiver Collars to a single Barrier Transmitter at one time. However, make sure any
Receiver Collar you do not wish to synchronize is turned OFF during the programming procedure. Any collar that is
within 30 inches of the Barrier Transmitter and turned ON may be reprogrammed. Familiarize yourself with the steps
outlined below before attempting to program the Barrier Transmitter and Receiver Collar.
To prevent an unintended correction, do not perform set up procedures while the Receiver Collar is on your pet.
1. Gather the Receiver Collar(s) you wish to synchronize with the Barrier Transmitter. Turn the Receiver Collar(s) ON
and place less than one foot from the Barrier Transmitter.
2. Turn the Barrier Transmitter OFF by pressing the (-) button until there are no bars displayed in the LCD window.
Remove the back cover.
3. The mode switch is located inside the transmitter and
is preset to mode A. Move the switch to the center
position for mode B or to the right position for mode
AB (5A). Once you have selected the desired mode,
replace the back cover.
Note: If you have selected mode AB you do not need
to proceed with programming the receiver in the next
steps. Receiver Collars set to mode A or mode B will
each receive the radio signal from a Barrier Transmitter
set to mode AB.
Inside
Back
Cover
Transmitter
Inside
View
5A