Petsafe Petporte Smart Flap® Microchip Cat Flap - Manual (Page 13)

13
Petporte smart fl ap ® Quick Guide
Function Button Activation Mode Button Function
Normal Mode This is the default mode on powering up
and requires no button activation.
Night Mode (Timer Mode) Press the Red Button for
less than 2 seconds The red light will illuminate.
In Night Mode: During the hours of
darkness, the green light will illuminate.
The unit will not allow the cat to exit. At
dawn, the green light will extinguish and
the lock opens and the cat can go outside
again until dusk.
In Timer Mode: The unit will Lock and
Unlock at specifi c programmed times of day.
Vet Mode Press the Red Button for
more than 2 seconds The red light will then fl ash and the unit
will not allow any cats to go out.
Program Entry Press and hold the Green Button for
more than 10 seconds The green light will fl ash and you then
have 30 seconds in which to program
your cat by passing the animal under
the porch.
Extended Modes Press and hold both the Red and Green
Buttons for more than 2 seconds The unit will emit a long beep indicating
that the extended modes are now
available and the green light will be lit.
(See the Extended Modes - Quick Guide
on page 14)
Key Pad Lock Press and hold the Red Button for
more than 30 seconds The unit will emit a series of beeps
indicating the unit is now locked.
Erase Mode Press and hold both the Red and Green
Buttons for more than 30 seconds The unit will emit a series of short beeps
followed by a long beep. Both lights
should now be fl ashing.
Note: Once the unit’s memory has been
erased, it will have to be re-programmed
before further use!
Reset to Normal Mode Press and hold the Green Button for
more than 30 seconds The unit will emit a series of short beeps
followed by a long beep. Both lights
should extinguish. Hold both buttons
down simultaneously for more than 30
seconds and UPON RELEASE the unit
emits a long beep.