Petsafe Petporte Smart Flap® Microchip Cat Flap - Manual (Page 18)

18
LED Indicator - Quick Guide
Explanation of LED Indicators:
Function
Flash Flash Power on but nothing programmed
Off Off Normal Operating Mode
Off (Day) / On (Night) On Night Mode (Timer Mode)
Off Flash Vet Mode
Flash Off Open Mode
On Flash Battery Level Low
Battery Backup Facility
Your Petporte smart fl ap ® has the facility to fi t a backup battery, ensuring your cat can still have access to your house in the event of a
power cut on the low voltage power supply.
To install batteries, remove the small cover plate with a screw driver and attach a 9-volt PP3 battery to the connecting snaps. Push
battery into the battery compartment and snap the small cover plate back in place.
Please note that the following functions are currently unavailable with your Petporte smart fl ap ® , when the unit is being operated by battery alone:
1. Wall Mounting - Currently the Petporte smart fl ap ® Battery Backup Facility is unable to function on a wall fi tted unit.
2. Night Mode - Currently Night Mode is unavailable when the unit enters battery backup mode.
To set the LOCK time: This function needs to be carried out at the time of day when you wish the unit to CLOSE and remain LOCKED.
Enter the Extended Modes by pushing the Red and Green buttons simultaneously for more than 2 seconds, then press the red button
once (the unit will beep twice) then again (the unit will beep three times) then again (the unit will beep four times) then again (the unit
will beep fi ve times) then once again (the unit will beep six times) then once again and the unit will beep 7 times and you have arrived
at Timer Mode. To enter Timer Mode, press both Red and Green buttons simultaneously, the green light will stay illuminated and the
red light will fl ash.
Pressing and releasing the Red button quickly will set the LOCK time. On releasing the Red Button the Petporte smart fl ap® will return
to its normal mode of operation.
You must now activate Night Mode so that the unit recognizes the UNLOCK and LOCK times that you have programmed. To
activate Night Mode, press the Red button for less than 2 seconds.
Note:
1. The Timer Mode will only function when the unit is powered through the external power supply included with this unit. The Timer
Mode is not available when the unit enters battery backup mode.
2. In the event of a power cut, you will need to reset the unlock and lock times.
3. The Timer Mode supersedes the light level detector. The unit will no longer read the ambient light levels to decide if the unit should
be locked or unlocked.