Petsafe Wireless Pet Containment System PIF-300-21 - Manual (Page 22)

22 www.petsafe.net
EN
FR
ES
NL
IT
DE
My next-door neighbor has
an In-Ground Containment
System and the Receiver Collar
does not activate near
their property. • Your neighbor’s In-Ground Fence signal may interfere with
the operation of the Receiver Collar preventing activation
close to their fence. To minimize the interference, reduce the
size of the Pet Area or move the Transmitter away from the In-
Ground Fence System.
• Adjust the Pet Area so that the Receiver Collar activates
for at least 1.5 m (5 ft) beyond the reduced Boundary setting
when walking towards the In-Ground Fence.
The Receiver Collar has injured
my pet’s neck. Failing to follow the important safety information at the
front of the Operating and Training Guide has caused
pressure ulcers. Some descriptions of advanced pressure
ulcers describe the sores as looking like burns on the dog’s
neck. Be assured that electronic collars do not use enough
energy to create electrical burns. The energy in an output
pulse is only a few thousandths of a Joule; it is similar in
nature to the static pulse that you may feel when getting out
of your car. In some cases, pressure ulcers are described
as chemical burns.The RFA-67D-11 battery is sealed when
installed in the Receiver Collar housing. This sealing makes
it virtually impossible, without misuse or abuse, for your
Receiver Collar battery to leak onto your pet’s neck. Please
review and follow the important safety information on page
2, and the instructions in Step 5 under the heading “Fit the
Receiver Collar”.
Re-synchronize the System
1. Remove the Receiver Collar from your pet.
2. Remove the battery from the Receiver Collar. Discharge all power by holding the Stimulation Level
Button down until the LED is no longer illuminated.
3. At the transmitter, move the Boundary Switch from the low to the high position.
4. Slowly adjust the Boundary Control Dial up to 8, down to 1 and then back to the #4 position.
5. Standing within 1.5 m to 3 m (5 ft to 10 ft) of the Transmitter, reinsert the battery into the Receiver Collar.
6. Test the Boundary and verify operation by walking out into the Pet Area until your Receiver Collar responds.
With the Transmitter set to 4, it should activate approximately 12 m to 15 m (40 ft to 50 ft) away.
Once you are confi dent that the system is working, reset the Transmitter controls to the original setting.
Battery Disposal
This device operates on one battery of the type Lithium 6-Volt with 240 mAH capacity. Replace only
with equivalent battery received from calling the Customer Care Centre. For a listing of Customer
Care Centre telephone numbers, visit our website at www.petsafe.net. Separate collection of spent
batteries is required in many regions; check the regulations in your area before discarding spent
batteries. Please see page 8 for instructions on how to remove the battery from the product for
separate disposal.