Ryobi CSB122 - Manual (Page 12)

1
ASSEMBLy
REMOVING BLADE
See Figure 4.
 Unplug the saw.

Depress spindle lock button.
 Remove blade screw by turning it counterclockwise with
the blade wrench.
 Remove spring washer and outer blade washer (“D”
washer).
 Lift lower blade guard.
 Remove blade.
Fig. 4
BLADE
WRENCH
BLADE
SCREW
SPINDLE
LOCK
BUTTON
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:

Cutting all types of wood products (lumber, plywood,
paneling)
 Cross cutting/Rip cutting
 Bevel cutting
 Pocket cutting
OPERATION
KICKBACK
See Figures 5 - 8.
Kickback occurs when the blade stalls rapidly and the saw
is driven back towards you. Blade stalling is caused by any
action which pinches the blade in the wood.
DANGER:
Release switch immediately if blade binds or saw stalls.
Kickback could cause you to lose control of the saw. Loss
of control can lead to serious injury.
To guard against kickback, avoid dangerous practices such
as the following:

Setting blade depth incorrectly
 Sawing into knots or nails in workpiece
 Twisting the blade while making a cut
 Making a cut with a dull, gummed up, or improperly set
blade
 Supporting the workpiece incorrectly
 Forcing a cut
 Cutting warped or wet lumber
 Operating the tool incorrectly or misusing the tool