Ryobi CSB122 - Manual (Page 20)

0
OPERATION
OPTIONAL RIP GUIDE
See Figure 22.
Use the optional rip guide, part no. 96986-009, when mak-
ing long or wide rip cuts with your saw.
To assemble rip guide:

Unplug the circular saw.
 Place rip guide through holes in base as shown in the
figure.
 Adjust rip guide to the width needed.
 Tighten rip guide screw securely.
To use rip guide:

Secure the workpiece.
 Position the face of the rip guide firmly against the edge
of workpiece.
 Guide the saw along the edge to achieve a straight rip
cut.
NOTE: The guiding edge of the workpiece must be straight
for the cut to be straight. Use caution to prevent the blade
from binding in the cut.
OPTIONAL DUST NOZZLE KIT
See Figure 23.
You may purchase a dust nozzle kit, part no. 9889-001,
for use with the saw. The adaptor fits over the dust chute
which is located on the upper blade guard. The nozzle at-
taches to the adaptor.
NOTE: If you use the nozzle, you should always connect it
to a standard vacuum hose.
To attach dust nozzle:

Unplug the circular saw.
 Lift lower blade guard.
 Orient adaptor to fit into the dust chute opening on upper
blade guard.
 Secure adaptor with screw provided.
 Align hole in nozzle with raised lip on adaptor and snap
into place when using a vacuum hose.
Fig. 3
RIP GUIDE
RIP GUIDE
SCREW
ADAPTOR
RAISED
LIP
SCREW
NOZZLE
HOLE
DUST
CHUTE
Fig.