Ryobi CSB122 - Manual (Page 18)

18
OPERATION
0° BEVEL STOP
See Figure 19.
The saw has a 0° bevel stop that has been factory adjusted to
assure 0° angle of the saw blade when making 90° cuts.
To check 0° bevel stop:

Unplug the circular saw.
 Place the saw in an upside down position on a work-
bench.
 Check the squareness of the saw blade plate to the base
of the saw using a combination square.
To adjust 0° bevel stop:

Unplug the circular saw.
 Loosen wing nut.
 Loosen hex nut securing adjusting screw.
 Turn screw and adjust base until square with saw
blade.
 Tighten hex nut and wing nut securely.
WARNING:
Attempting a bevel cut without having the wing nut
securely tightened can result in serious injury.
LENGTH OF CUT SCALE
See Figure 20.
The saw is equipped with a length of cut scale on its base.
It is parallel with the saw blade and can be used to measure
the distance into the material the blade cuts.
NOTE: Six inches is the maximum length of cut that you can
measure. Also, it is accurate only when the depth of cut is
set at full maximum depth.
Fig. 0
HEX NUT
WING NUT
CARPENTER’S
SQUARE
LENGTH OF CUT SCALE
Fig. 19