Canon DR-5080C EN - Manual (Page 6)

5
1
S T E P
4 Place one page of the stack on the document tray, and set the paper
guides to match the width of the document.
▲
S T E P
5 Use the application software to instruct the scanner to start scanning.
At this point, the Start key on the operation panel will change colors
from red to green. This means that the scanner is ready to accept
your document.
▲
S T E P
6 Prepare the stack of papers so that the stack’s edges are even. Then
load the stack onto the document tray with the documents face up,
their top edge inserted first into the scanner. A sensor located on the
document tray will detect the documents and start scanning.
To scan more pages, reload the document tray and the scanner will start scanning
automatically. To end scanning, press the Stop key.
▲
WHEN USING AUTO MODE
S C A N N I N G B A S I C S