Ryobi TS1141 - Manual (Page 14)

14
ASSEMBLy
Fig. 8
WARNING:
Always make sure the compound miter saw is securely
mounted to a workbench or an approved workstand. Failure
to heed this warning can result in serious personal injury.
MOUNTING THE MITER SAW BASE TO THE
STAND
See Figure 8.
If a stand was included with your miter saw, follow the in-
structions below to mount the saw base to the stand. If a
stand was not included and your saw came preassembled,
or if you prefer to mount to a workbench, proceed to the
next section, Mounting Holes, to mount the miter saw to
a workbench.

Place the miter saw base on the stand so that the base is
seated firmly on the stand and the holes in the bottom of
the base are aligned with the threaded shaft of the knobs
in the stand.
 Tighten the knobs securely, but do not overtighten.
trace hoLes
at these Locations
for hoLe pattern
Fig. 9
Mounting
surface
base
trace hoLes
at these Locations
for hoLe pattern
MOUNTING HOLES
See Figure 9.
If not using a stand, the saw should be mounted to a firm
supporting surface such as a workbench. Four bolt holes
have been provided in the saw base for this purpose. Each
of the four mounting holes should be bolted securely using
1/4 in. machine bolts, lock washers, and hex nuts (not
included). Bolts should be of sufficient length to accommodate
the saw base, lock washers, hex nuts, and the thickness of
the workbench. Tighten all four bolts securely.
The hole pattern for mounting to a workbench is shown in
figure 9. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
saw base
stand
knobs