Ryobi TS1141 - Manual (Page 30)

30
ADJUSTMENTS
DANGER:
Laser radiation. Avoid direct eye contact with light
source.
WARNING:
Use of controls or adjustments or performance of pro-
cedures other than those specified herein may result in
hazardous radiation exposure.
TO ADJUST THE LASER GUIDE
See Figure 40.

Use the work clamp or a C-clamp to secure a piece of
scrap wood.
 Plug the saw into the power source and make a slight cut
to score the wood.
 Release the switch trigger and allow the saw blade to
stop rotating before raising the blade.
 Raise the saw arm.
 Unplug the saw.
 To adjust the laser, loosen the laser adjustment screw
using the Phillips end of the supplied blade wrench.
NOTE: When properly aligned, the laser should be on the
left edge of the kerf.
 Once aligned, tighten the screw then remove the blade
wrench.
TO ADJUST THE MITER LOCK LEVER
See Figure 41.
Prior to squaring the saw blade to the fence, check and
adjust the miter lock lever, if needed. In the “locked” posi-
tion, the action of pushing the miter lock lever fully down
should feel tight and secure. Considerable effort should be
required to move the miter table. If the table moves easily
when in the “locked” position, an adjustment of the miter
lock lever is required.
To adjust:

Unplug the saw.
 Push the miter lock lever fully down to lock.
 Pull the miter lock lever out to the right to disengage, then
pull forward to adjust.
 Release miter lock lever to re-engage
 Recheck the miter table to ensure proper tightness.
Fig. 40
Fig. 41
Lock
unLock
Miter
Lock
Lever
Laser adJustMent
screw