Ryobi TS1141 - Manual (Page 21)

Miter
tabLe
square
beveL
Lock
knob
Miter
fence
bLade
21
ASSEMBLy
scaLe
indicator
Miter
scaLe
indicator
screw beveL
scaLe
SQUARING THE BLADE TO THE MITER TABLE
See Figures 25 - 28.

Unplug the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Lift the miter lock lever.
 Rotate the miter table until the pointer aligns with zero
on the miter scale.
 Push the miter lock lever down to lock the miter table.
 Loosen bevel lock knob and set saw arm at 0 ° bevel (blade
set 90 ° to miter table). Tighten bevel lock knob.
 Place a square against the miter table and the flat part
of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 Rotate the blade by hand and check the blade-to-table
alignment at several points.
 The edge of the square and the saw blade should be
parallel as shown in figure 26.
 If the top or bottom of the saw blade angles away from
the square as shown in figures 27 and 28, adjustments
are needed.
 Loosen the bevel lock knob.
 Adjust positive stop adjustment screw to bring saw blade
into alignment with the square. See Positive Stop Adjust-
ment in the Adjustments section.
 Retighten bevel lock knob. Recheck blade-to-table align-
ment.
NOTE: The above procedure can be used to check blade
squareness of the saw blade to the miter table at both 0
°
and 45 ° angles.
The saw has two scale indicators, one on the bevel scale
and one on the miter scale. After squaring adjustments have
been made, it may be necessary to loosen the indicator
screws and reset them to zero.
Fig. 26
correct view of bLade square with Miter tabLe
view of bLade not square with Miter tabLe,
adJustMents are required
Fig. 27
Fig. 28
view of bLade not square with Miter tabLe,
adJustMents are required
Fig. 25
Miter tabLe square
beveL
Lock
knob
Miter
fence
Miter tabLe
square
beveL
Lock
knob
Miter
fence
bLade
bLade