Ryobi TS1355L - Manual (Page 16)

16
ASSEMBLy
Fig. 1
StoP
Block SMall
wing
Screw
taBle
eXtenSion
Fig. 13
Fig. 14
Fig. 15
Saw vieweD FroM BottoM
claMP
Bracket
aSSeMBleD
taBle
eXtenSion
Bracket
SuPPort
Miter
Saw BaSe
Miter
Saw BaSe
StoP
Block
BaSe
ADJUSTABLE TABLE
See Figure 12.
The adjustable table can be used on either the left or right side
of the miter saw. To install:

Slide the adjustable table on either table extension, then
insert the table extensions into the saw base.
 Use the lock screw to secure the adjustable table to the table
extension. Tighten lock screw securely.
TABLE EXTENSIONS
See Figures 12 - 14.
To use the stop block and/or adjustable table, slide on the
desired table extension.
To install table extensions, insert the ends of extensions into
the holes in the sides of the base. Adjust the extensions to the
desired length.
Secure extensions in place by positioning a clamp bracket un-
der each table extension beneath the miter table. Orient each
clamp bracket as shown in figure 14.
Secure each clamp bracket in place with a clamp bracket
screw. The clamp bracket screw threads through the clamp
bracket and tightens against bracket support on bottom of
miter table, securing clamp bracket against table extension.
STOP BLOCK
See Figures 12 and 15.
The stop block is included with the table extensions and is
useful as a stop for making repetitive cuts to the same length.
It can be installed on either side of the saw base:

Slide the stop block on the back arm of either table
extension, then insert the table extensions into the saw base.
 Use the small wing screw to secure the stop block to the
table extensions.
 Loosen the small wing screw and adjust the stop block the
desired distance from the blade for the cut to be made.
For accurate placement of the stop block, measure the
distance from the teeth set on the blade to the stop block.
 Tighten wing screw securely.
 Plug the saw in.
 Make a test cut in scrap material and measure the length of
the workpiece.
 Make any necessary adjustments.
claMP
Bracket
claMP Bracket
Screw
aDjuStaBle
taBle