Ryobi TS1355L - Manual (Page 32)

3
MAINTENANCE
Fig. 46
A
L
K A L INE
C
E
L
L
A
L
K
AL I N E C
EL
L
A
L
K
A
L INE CE LL
negative (–)
laSer guiDe
SuPPort
BatterieS
CHANGING TH E BATTERIES
See Figures 45 - 46.

Unplug the saw.
 Remove the laser guide from the saw and lay it on a flat
surface with the two phillips screws facing upward.
 Remove the screws and separate the laser guide cover
from the laser guide support.
 Remove the three button cell batteries using a non-con-
ductive device such as a toothpick.
NOTE: Replace the batteries with silver oxide batteries that
have a rating of 1.5 volt and 180 mah (milliampere hour)
minimum (Number 357 silver oxide only).
When replacing the batteries, the laser guide should be
thoroughly cleaned. Use a soft paintbrush or similar device,
to remove all sawdust and debris.
Do not attempt to activate the laser.
The laser is activated by means of a centrifugal switch
only while the saw motor is running and the laser guide is
mounted on the saw.
 After cleaning the laser guide and replacing the batteries,
secure the laser guide cover to laser guide support using
the two phillips head screws. For proper assembly, be sure
to align the key on the laser guide cover with the key slot
in the laser guide support. Tighten screws securely.
NOTE: Aperture in laser guide cover must be aligned with
aperture in laser guide support.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
Fig. 45
DANGER: Laser radiation when open and inter-
lock defeated. AVOID DIRECT EYE EXPOSURE.
ScrewS
laSer guiDe
cover
laSer guiDe
keY
Slot
aPerture
aPerture
laSer guiDe
SuPPort
(uPSiDe Down view)
keY
PlaStic
BatterY
inSulator
M
AX
IM
UM
OU
TP
UT:
<5
MW
WAVELENGTH: 65 0 N
M.
CL
AS
S
III
A
LA
SE
R
PR
OD
UC
T
LA
SE
R
RA
DIA
TIO
N
AVOID DIREC
T E
YE
EX
PO
SU
RE
DANGER