Ryobi TS1355L - Manual (Page 28)

8
OPERATION
Bevel
Angle
Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
. Miter table set right 31.6°
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
. Miter table set left 31.6°
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
. Miter table set left 31.6°
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
. Miter table set right 31.6°
3. Save right end of cut
33.85°
33.85°
33.85°
33.85°
CUTTING MOLDING USING THE CROWN
MOLDING STOP
See Figures 38 - 39.
To use this method for accurately cutting crown molding
for a 90° inside or outside corner, place the crown molding
upside down on the miter table.
Keep in mind that the angles for crown moldings are very
precise and difficult to set. Since it is very easy for these
angles to shift, all settings should first be tested on scrap
molding. Also most walls do not have angles of exactly 90°,
therefore, you will need to fine tune your settings.
When cutting crown molding by this method the bevel
angle should be set at 0°. The miter angle should be set at
45° either right or left, depending on the desired cut for the
application.

Loosen the crown molding stop by turning the knob
counterclockwise.
 Place the stop in the hole on the left side of the saw’s
base. See Figure 38.
 With the bottom of the molding (wall side) against the
miter fence and the top of the molding (ceiling side)
against the miter table, align with the desired mark on
the throat plate then spin the crown molding stop until it
fits snuggly against the crown molding.
 Secure the crown molding stop in place by turning the
knob clockwise.
 Hold the crown molding in place with your left hand.
NOTE: NEVER have your hand inside the no hands zone
while the saw is on.
 Slowly lower the blade into and through the workpiece.
 Release the switch trigger and allow the blade to stop
rotating before raising the blade out of workpiece. Wait
until the electric brake stops blade from turning before
removing the workpiece from miter table.
crown
MolDing
StoP
knoB
Fig. 38
Fig. 39