WEATHER GUARD Model 9873-3-01 Door Organizer, open trays, 21-3/4 in x 20-1/4 in - Manual

1
Be safe - always wear protective eye-
wear to keep debris out of your eyes
when installing WEATHER GUARD ®
Van Products.
CAUTION
INSTALLATION MANUAL
Door Tray Units
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
WWW.WEATHERGUARD.COM
VAN STORAGE SOLUTIONS
FOR THE WAY YOU WORK TM
*24-0065* Part No. 24-0065 REV. E ECN 5305 04/13
TOOLS REQUIRED
• Electric Drill
• 13/32" Drill Bit
• 7/16" Opened or Box End Wrench
• 9/16" Opened or Box End Wrench
DESCRIPTION QTY.
1/4" Lock Washers 6
1/4" Flat Washers 6
1/4-20 x 3/4" Hex Head Bolts 6
1/4-20 x 2-1/4" Black Oxide Bolt 1
1/4-20 Blind Fasteners 6
Blind Fastener Installation Tool 1
BOLT KIT
Prior to drilling, check under vehicle for fuel
tanks, fuel lines, brake lines, electric wires, etc.
to avoid cutting or puncturing them. Do not use
Blind Fasteners in these areas.
WARNING
7/16 Wrench
(Or 7/16 Socket)
Black Oxide Bolt
Flat Washer
9/16 Wrench
Installation Tool
Blind Fastener
Place a drop of oil on the black
oxide bolt before assembling as
shown on right. Place the Blind
Fastener in the hole and use
a 7/16 wrench to tighten black
hex bolt until the Blind Fastener
is fully seated. When setting
black hex bolt, it will start out
hard. As the Blind Fastener
“bulbs” out it will get easier,
until it bottoms out or sets.
Make sure the Blind Fastener
and Installation Tool do not turn
during installation.
INSTALLING BLIND FASTENERS
INSTALLATION STEPS
STEP 1. If rear doors have inner trim panels, remove them to the best location to bolt. This will help
locate hidden wires so you don't cut them when drilling.
STEP 2. Position Door Tray on door and make sure at least four of the six holes can be used for fastening
to the door. If six holes cannot be used, drill new holes in the panel. Mark holes and drill with a 3/8" drill bit.
Install Blind Fastener, see instructions for installation.