Caution – WEATHER GUARD Model 2505 Mounting Bracket, KUV User Manual
Page 2
If you have any questions, please give us a call. Call Toll Free 1-800-456-7865
WEATHER GUARD® products are protected by one or more of the following patents:
U.S. - 5145087, 5308126, 4509787, 4573731, 4618083, D-346355, D-346994, D-353574; Canada - 1218968, 1224230, 1235100 and; U.K.- 2233036.
other patents pending.
KNAACK LLC
420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, USA 60014
815-459-6020
©2004 Knaack LLC
- NOTICE -
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
5/16-18 x 4" Fasteners sup-
plied with Model 281
(4)
5/16-18 x 1-1/4"
Hex Head Bolt
(8)
5/16-18 Nylon
Lock Nut
(8)
5/16 Bonded
Steel/Rubber
Washer
(8)
Fender Washer
(8)
NOTE: Follow the instruction manual,
supplied with the Hi Cube ladder rack, up
to the "Vehicle Mounting Procedure"
section. Read and have an understand-
ing of both the instructions listed below
and the steps in the "Vehicle Mounting
Procedure" section in order mount the
ladder rack to the KUV.
1.) Use the 5/16-18 x 4" fasteners (supplied
with the Hi Cube ladder rack bolt kit)
to connect the rack assembly to the
KUV Mounting Bracket.
2.) Position the rack assembly on the
KUV roof. Keep the 3" to 6"
clearance between the handle and
the back of the body (As shown below
left).
3.) Set the mounting feet approximately 2"
from the top edge of the roof.
4.) Mark (8) .343 dia. holes using the
mounting feet as a template,then drill.
5.) Place unit on the vehicle with one rubber
pad under each mounting foot. Tighten all
fasteners.
6.) Continue with the "Ladder and Cylinder
Adjustments" section of the Hi Cube
instruction manual.
.343 dia. hole
(8)
3" x 7"
Rubber Pad
(4)
CAUTION
To keep debris out of your
eyes when drilling, always
wear protective eyewear.
3" - 6"
22-1/2" - 25-1/2"
Back of van
Part No. 24-0191 REV. B ECN 5315 05/13
2