Xtreme 51870: Bluetooth Speaker User Manual

Page 5

Advertising
background image

to the hands-free automatic shutdown to loosen the hand, the hands-free has restore factory
settings (without any Bluetooth hands-free memory device is matched), restart the restore
factory settings.

11. Lower voltage protection of battery.
When the battery voltage is low to 3.3V, will hear the voice prompt "low battery", the red LED
lights flash once every three seconds, when the voltage is less than 3.0V, hands-free
automatically shut down.

12. LED indication

Speakerphone Status

Red LED

Blue LED

Sound

Voice report

Off Mode

Off

Off

Power On

On for 2 sec

On for 3 sec

Yes

Power Off

On for 3 sec

Yes

Standby before pairing

Flash on every 3 sec

Standby after pairing

Flash on every 3 sec

Yes

Standby low Voltage

Flash on every 3 secretary

Flash on every 3 secretary

Yes

Call state

Flash on every 3 secretary

Yes

pairing in progress

Flash on alternately

Yes

pairing Completed

Flash on every 3 sec

Short beep

Charging in Progress

Steady on

Charging Completed

Off


13. Care and Maintenance
(1) Do not expose the speakerphone to liquid, moisture or humidity, as it is not water proof
(2) Do not use abrasive cleaning solvents to clean the speakerphone.
(3) Do not place the speakerphone in high temperature, as it may result in an explosion
(4) Do not expose the speakerphone to sharp objects as this will cause scratching and damage.
(5) Do not attempt to disassemble the speakerphone, as it does not contain serviceable components.
(6) If you do not use the speakerphone for the long time, be sure to store it in a dry
Place, room temperature.

The hands-free battery should be stored separately


14. Safety information
(1) Check local laws regarding use of a mobile phone and speakerphone while
driving. if you use the speakerphone while driving, ensure your attention and
focus remains on your responsibility of driving safety.
(2) Never allow children to lay with the speakerphone. Small parts may be a
choking hazard.
(3) Observe all signs that require an electrical device or RF radio product to be
switched off in the designated areas. These could include hospitals, blasting

Advertising