Y-cam EyeBall Range User Manual
Page 81
Page 81
13. Type this command in to the prompt: "tftp -i 192.168.168.1 put YOUR_FIRMWARE_NAME.mfw"
14. You will need to replace YOUR_FIRMWARE_NAME.mfw with the name of the firmware you downloaded (step 3)
15. Press Enter after typing the command.
16. The camera's green LED will stop flashing. This means the firmware is being loaded.
17. Please wait until the LED starts flashing again – this means the firmware has finished installing.
18. Turn the power off to the camera.
19. Unplug the crossover cable.
20. Restore your TCP/IP Settings to their previous state (as in step 5)
Your camera should now be restored to its factory default settings and be working again – you can proceed to the start
of the manual and setup your camera as normal.