Y-cam EyeBall Range - Manual (Page 16)

Page 16
3.0 INSTALLATION
For initial setup, you need to connect the Y-cam directly to your router or switch with a network cable. You cannot
connect wirelessly to the camera without first setting it up via a network cable.
You should connect the Y-cam directly in to your internet router (normally supplied by your broadband provider) or a
network switch or hub (that is connected to your computers network).
Using the standard Ethernet network cable, plug this in to the network connection socket on the Y-cam at one end, and
plug the other end in to a spare port on your router/switch.
Using the Power Adaptor (supplied), plug one end in to the Power Connection socket on the Y-cam. Plug the other end
in to an electrical socket and turn the power on.
The Connectivity Status LEDs will light up*. Your router/switch will then begin to communicate with the camera.
You can now proceed to the Software Installation section.
* - The Y-cam Bullets Status LED is located inside the camera behind the lens and infrared LEDs