Wilbur Curtis TLCG1509S - Manual (Page 2)

1. Daily, Rinse the unit after use.
a. Rinse unit with hot water.
b. Fill unit with hot water.
c. Open unit and empty contents completely.
2. Clean and sanitize the lid assembly.
a. Remove the lid from the server and clean it thoroughly.
b. Using a tube cleaning brush, clean inside the filling tube.
c. Rinse with clean water.
d. Submerse in sanitizing solution for 5 minutes then air dry completely.
3. Cleaning and sanitizing body assembly.
a. Fill the unit with cleaning solution. With a sponge brush, thoroughly clean inside the liner.
b. Rinse the unit with a fresh water rinse.
c. Fill unit with sanitizing solution. Allow to sit for 5 minutes then drain through the faucet.
d. Wipe outside of unit with clean cloth moistened with cleaning solution.
e. Place body assembly upside down on rack to thoroughly air dry.
4. Cleaning the faucet parts.
a. Unscrew the bonnet/handle assembly from the faucet and disassembly removing spring, seat cup and shaft.
b. Clean and rinse parts. Place in sanitizing solution for 5 minutes, remove and air dry.
c. Use a tube brush soaked in cleaning solution to clean the faucet shank. Push the brush into the center tube of the faucet
shank and scrub it. Rinse by pouring water from inside the unit, allowing rinse water to flow into a sink until water runs clear.
5. When all pieces are completely dry reassemble for use.
TLCG1509S Milano 1.5 Gallon Server Rough-In Drawing
2
Ш 5”
(Ш 12.7 cm)
13.75”
(35.0 cm)
9.5”
(24.1 cm)
22.5”
(57.2 cm)
8.125”
(20.6 cm)
9”
(22.9 cm)
8.875”
(22.5 cm)
CAUTION
Do not immerse in water.
Do not place in dishwasher.
Do not use harsh powders or cleansers containing chlorine.
Do not use a wire brush or pot scour to clean inside liner.