Wilbur Curtis TXSG1501S600 - Manual (Page 2)

2
CAUTION
Do not immerse in water.
Do not place in dishwasher.
Do not use harsh powders or cleansers containing chlorine.
Cleaning Instructions
These cleaning and sanitizing instructions are only a guide line to be used for the cleaning and sanitizing of the TLXS dispenser.
Your current in-house cleaning and sanitizing methods may be just as effective.
1. Daily – Rinse the unit between brews.
a. Rinse unit with hot water and empty completely.
b. Dry outside surfaces with a cleaning rag.
b. To preheat, fill the insulated server with hot water and allow it to heat before emptying hot water. The empty server is
` now ready for brewing.
2. Cleaning the lid assembly.
a. Unscrew the top lid from the insulated server and wash it in cleaning solution.
b. Using the supplied brush, clean inside the filling tube.
c. Rinse with clean water.
3. Cleaning and sanitizing body assembly.
a. Partially fill the insulated server with cleaning solution. Use a sponge brush to thoroughly clean inside liner.
b. Rinse the unit using a fresh water rinse.
c. Pour sanitizing solution into the insulated server. Allow to sit for 5 minutes then drain through the faucet.
d. Rinse by pouring water inside the unit, allowing rinse water to flow into a sink until water runs clear.
e. Wipe outside of unit with clean cloth moistened with a mild cleaning solution.
f. Place body assembly upside down on rack to thoroughly air dry.
4. Cleaning the faucet parts.
a. Remove faucet (see Removing the Faucet on page 1) and gauge glass from unit and brush out with cleaning solution.
b. Place in cleaning solution to soak for 5 minutes,
c. With the faucet removed, use the tube brush soaked in cleaning solution to insert through the faucet shank.
d. Rinse parts and dry.
5. Assemble parts that were removed.
Rough-In Drawing
9.00”
(22.9 cm)
3.375”
(8.6 cm)
Ø9.125”
(23.2 cm)
22.75”
(57.8 cm)
8.875”
(22.5 cm)
14.375”
(36.5 cm)
8.25”
(21.0 cm)
2.125”
(5.4 cm)