Cobra Electronics microTALK MT 800 - Manual (Page 2)

NOTE: Estimated operation time
on full charge: 12 hours.
These rechargeable batteries
must be recycled or disposed
of properly in compliance with
all applicable laws. They must
not be thrown in the rubbish bin. Some countries
and local authorities require recycling and have
established collection programs. Please contact
your local waste disposal authority for instructions.
WARNING: Do not put batteries into fire or expose
to high heat. They may explode.
For Charging microTALK ® Radio(s):
1. Check to see that the batteries have been
inserted properly. See
above for battery
installation instructions.
2. Insert round connector of
wall charger into the
charge jack located at the
top of the radio. The wall
charger has two (2) round
connectors which enables
you to charge either one
or two (2) radios at a time.
3. Plug the wall charger into electrical outlet.
It is not recommended to recharge batteries more
than 24 hours. Estimated operation time on a full
charge is 12 hours.
Use only the supplied rechargeable batteries and
wall charger for recharging your microTALK
®
radio. Non-rechargeable alkaline batteries can also
be used.
OPERATION
Product Information
This microTALK ® radio has been manufactured to
meet all required standards for radio equipment
using PMR 446 frequencies as authorized. The
use of this two-way radio product involves the
public airways and its use may be subject to local
laws or regulations. Contact your radio licensing
authority for more information.
Caring for Your Radio
Your microTALK ® radio will give you years of
trouble-free service if cared for properly. Here are
a few suggestions:
• Handle the radio gently.
• Keep it away from dust.
• Never put the radio in water or in a damp place.
• Avoid exposure to extreme temperatures.
Charger and Rechargeable
Batteries
To Insert Batteries in
Radio:
1. Remove belt clip by
releasing belt clip latch and
sliding clip up.
2. Pull up on lock tab to
remove battery cover (on
back of radio).
3. Insert batteries according to
polarity markings.
English
Each port can charge one radio. Uses 230-volt
adaptor.
Cobra recommends your radio is turned Off while
being charged.
Radio Power
To Turn Your Radio On:
Press and hold the
MODE/POWER button until
you hear a series of audible
tones indicating that the radio
is On.
Your microTALK
® radio is now in LISTENING MODE,
ready to receive transmissions. The radio is always
in LISTENING MODE, except when the TALK, CALL
or MODE buttons are pressed.
To Turn Your Radio Off:
– Press and hold the POWER button.
Battery Low Indicator
When battery power is low,
the BATTERY LOW indicator
will blink, indicating that
batteries should be recharged
or replaced.
WARNING: Only the supplied
NiMH batteries
can be recharged.
Battery/Power Saver
If there are no transmissions
within 10 seconds, the unit
will automatically switch to
Battery Save Mode and
POWER SAVER will appear in
the display. This will not affect the unit’s ability
to receive incoming transmissions.
Communicating with
Another Person
1. Press and hold the TALK
button.
2. With the microphone about
5 cm (2 inches) from your
mouth, speak in a normal
voice.
3. Release the button when
you have finished talking
and listen for a response.
You cannot receive incoming
calls while pressing the TALK button.
NOTE: Both radios must be tuned to the same
channel and privacy code to communicate.
Remove Belt Clip
Mode/Power Button
Lock Tab
Insert Batteries
5 cm (2 Inches)
From Mouth
Talk Button
Battery Low
Power Saver
Wall Charger
Insert Connector