Concord Camera 5040 - Manual (Page 12)

11
OPERATING THE MULTI-CONTROLLER
The multi-controller is used to set shooting mode, to move cursor when the camera Menu is shown, and to
confirm the selection.
Push Up (“ ” is named hereafter)
• To set Flash mode in Shooting Mode.
• To move the cursor up when MENU screen is shown.
Push to Right (“ ” is named hereafter)
• To zoom in subjects in shooting mode or to magnify image in review mode.
• To move the cursor to right when MENU screen is shown
• To enter submenu.
Push Down (“ ” is named hereafter)
• To set Self-Timer in Shooting Mode and Video Mode.
• To move the cursor down when MENU screen is shown.
Push to Left (“ ” is named hereafter)
• To zoom out.
• To move the cursor left when MENU screen is shown.
• To set Thumbnail view in Review mode.
Press Down (“SET” is named hereafter)
• To enter submenu.
• To confirm the setting.
ABOUT MENUS AND SETTINGS
Use the menus as shown below to activate the various shooting and reviewing settings.
1. Press the MENU button.
2. Press or to switch between the REC/Playback Menu and Setup Menu.
3. Press
or to select a menu item then press the SET button or to
enter its submenu.
4. Press the , , or to select the settings you wish to set then press
the SET button.
5. Press the MENU button to close the menu window.
Multi-controller
PREPARING THE CAMERA
2592 x1944