Concord Camera 5040 - Manual (Page 9)

8
INSERTING AN SD CARD
The digital camera is equipped with a 32MB internal memory. If no SD card is inserted in the camera, all
pictures/video clips/audio clips recorded by the camera will be stored in the internal memory. When SD card
is inserted in the camera, all files recorded by the camera will be stored on the SD card by using the Design
Rule for Camera File System (DCF) protocol. The DCF protocol is designed to accommodate file and data
exchange between digital cameras and other devices. Photos that are taken by a DCF camera can be viewed
on DCF-compatible cameras from other manufacturers.
1. Turn off the camera.
2. Open the Battery/Memory Card Door.
3. Insert the SD card in the direction as shown in the figure aside.
4. Close the Battery/Memory Card Door.
Note: When the SD card is being written to, read, erased or transmitted to, the green operation lamp
located on the left side of the Power button will blink. Do not turn off the camera or open the Battery
Memory Card Door while the LED is blinking.
To remove the SD card
1. Turn off the camera.
2. Open the Battery/Memory Card Door.
3. Gently press on the edge of the SD card to release it.
4. Pull the card out and close the Battery/Memory Card door.
TURNING THE POWER ON/OFF
Press and hold the POWER button for more than 1 second to turn the camera on.
To turn off the camera
Press the POWER button to turn off the camera.
Note:
1. The camera will be powered off automatically after being idle for some time. The Auto-Off timing can
be changed in Setup menu.
2. If the camera cannot be powered on, the batteries may be drained. Replace or recharge the battery
and try again.
PREPARING THE CAMERA