BendixKing CAS 67A ACAS II - Manual (Page 49)

43 Rev 3 4/13 CAS 67A/67B ACAS II Pilot’s Guide
IdT initiates IDent feature for atC.
the outer knob on the left hand dual concen-
tric switch selects the traffic advisory display
range in nautical miles. the selected range is
annunciated on the traffic display. the range
annunciation is the maximum displayed
range to the front of the aircraft. the selected
range has no effect on the tCaS II logic giv-
ing tas and ras.
Controls and Displays
Note: Selected range is displayed in the upper right hand corner of a
TA/VSI.
the inner concentric knob on the left may include an on/off switch
(clockwise = on) and when pushed selects traffic advisory altitude dis-
play limits. the above/Below select knob has no effect on the tCaS II
logic giving tas and ras.
aBoVe 9000 feet above; 2700 feet below. typically used during climb
phase of flight.
norMaL 2700 feet above; 2700 feet below. typically used during en
route phase of flight.
BeLoW 2700 feet above; 9000 feet below. typically used during
descent phase of flight.
Note: All knobs are continuous rotatory and do not roll over or stop.
KFS 578A FUNCTION SELECTOR, ATC COdE SELECT &
MOMENTARY TCAS dISPLAY FLIgHT LEVEL SELECT
the outer concentric knob on the right selects the Mode S and tCaS
mode of operation.
rotating the function knob (CCW) to the tSt posi-
tion initiates a comprehensive self test lasting
approximately eight seconds. all segments of the
display are illuminated for 2 seconds, then the code
I
D
T
OFF
RANGE
PUSH
^
^
(Pushbutton)
TST
SBY
ON
ALT VFR
TA
TA/
RA
PUSH
FL
006-18201-0000-r003 CaS 67a_67B aCaS Pilots Guide 2013 0410_CaS 67a 4/10/13 11:11 aM Page 43