BendixKing CAS 67A ACAS II - Manual (Page 52)

46
1/2 selects the active transponder. the other unit is
placed in standby.
IdT initiates IDent feature for atC.
FId allows entry of an alphanumeric flight identifica-
tion. Selecting the right inner pushbutton will cycle
through the eight characters to be changed. rotating
the right inner knob will change the contents of the
selected (flashing) character.
the outer knob on the left hand dual concentric switch
selects the traffic advisory display range in nautical
miles. the selected range is annunciated on the traffic
display. the range annunciation is the maximum dis-
played range to the front of the aircraft. the selected
range has no effect on the tCaS II logic giving tas
and ras.
Note: Selected range is displayed in the upper right hand corner of a
TA/VSI.
the inner concentric knob on the left includes an on/off switch (push
on/off) and when rotated selects traffic advisory altitude display limits
(above, normal or Below). the above/normal/Below select knob has
no effect on the tCaS II logic giving tas and ras.
aBoVe 9000 feet above; 2700 feet below. typically used during climb
phase of flight.
norMaL 2700 feet above; 2700 feet below. typically used during en
route phase of flight.
BeLoW 2700 feet above; 9000 feet below. typically used during
descent phase of flight.
Note: All knobs are continuous rotary and do not roll over or stop.
CAS 67A/67B ACAS II Pilot’s Guide Rev 3 4/13
Controls and Displays
(Pushbutton)
(Pushbutton)
(Pushbutton)
006-18201-0000-r003 CaS 67a_67B aCaS Pilots Guide 2013 0410_CaS 67a 4/10/13 11:11 aM Page 46