BendixKing KGP 860 - Manual (Page 28)

24
Rev 6 Jan/2005 KGP 560/860 Pilot's Guide
Pressing the Self-Test switch as the Level One Self-Test is completed
will initiate Level Two of the internal test capability. Level Two provides
information about any faults the system may be detecting. Normally, this
will not be necessary. If a normal Self-Test is unsuccessful, a Level Two
test is automatically initiated by the system.
Further Self-Test levels may be accessed after Level Two by following
instructions to “Press to Continue” at the end of Level Two and so on.
These further levels provide information about the installation configura-
tion, part number, and software / database versions, etc. All levels of
Self-Test may be performed on the ground, but only Self-Test Level One
and Two are accessible during flight. If the “Not Available” annunciator
lamp illuminates during flight, a Self-Test will indicate the reason.
KGP 560/860 GA-EGPWS Self-Test: Level 1 Messages
KGP 560/860 GA-EGPWS Self-Test: Level 2 Messages
NOTE: This Level 2 list contains the most commonly heard messages.
Other messages may be given, depending upon installation / equipment
types. Messages may be heard in various combinations.
Normal Procedures