BendixKing KMD 540 - Addendum System KMD 850 - Manual (Page 16)

8
Rev 3 Jun/2004 KMD 850 Wx Radar Addendum
VERTICAL PROFILE
If the radar has vertical profile capability then the track line is also used
to select the area of the storm to observe vertically. Once the track line is
in the proper location then pushing the VIEW key will switch to vertical
profile view as shown. Pressing the VIEW key again will switch back to
horizontal profile view.
If the azimuth track angle is changed while the vertical profile view is
active, “WAIT” will be displayed just below the track angle indication (in
this case R 45) until the radar repositions the antenna.
OVERLAYS
The flightplan, lightning strikes and traffic can be overlaid on top of the
radar by pressing the OVLY key and using the appropriate softkeys to
turn the overlays on.
NOTE: The flightplan can only be overlaid on the radar if a heading
source is available.
KMD 850 Wx PG R3 7/2/04 8:54 AM Page 8