CANOGA PERKINS 2346 T3 Fiber Optic Modem - Manual (Page 13)

EdgeAccess Universal Chassis System
2346 T3 Modem 3-1
Chapter 3
Software Management
You can manage the 2346 through VT100 Terminal Emulation, which is accessible by a Telnet
session, HyperTerminal or similar terminal emulation software, a standard SNMP network manager,
and CanogaView. If the 2346 is in UCS 1000 or 1002 with a CIM within a domain that includes a
DMM, you can access the 2346 through the DMM. If the 2346 is a standalone or in a UCS 1001, you
must access the 2346 directly through the serial port for the enclosure or BAM.
Setting Up for Network Management
Typically, the 2346 runs within the network on an Ethernet connection, communicating with your
Network Management Platform.
Set Up the Network Management Platform
You must run several Management Information Bases (MIBs) on your Network Management
Platform in order to successfully manage this module. Before you start, check that Standard MIB (the
industry-standard mib) is loaded. In addition, download Cp.mib, a private mib that supports all
Canoga Perkins products, available from the Canoga Perkins web site. Go to www.Canoga.com,
click Support, then click Software Download, and follow the prompts on screen.
Set Up the PC for Terminal Operation
Connect the VT100 terminal emulation session to the DMM or directly to a 2346, either standalone or
in a UCS chassis. Setting up the VT100 session depends on which connection, serial port or Ethernet,
you have available for access to the VT100 management program. Canoga Perkins suggests that you
use HyperTerminal for your first session.
You must set up TCP/IP for the DMM or directly-managed 2346 before you can use Telnet; for
details, see the manual for the DMM or go to page 3-7.
Note: For details on the DMM, see the Model 1500 Domain Management Module User Manual (for
UCS 1000) or the Model 1502 Domain Management Module User Manual (for UCS 1002).
These steps briefly describe how to set up your PC for a terminal connection. For details on using
Windows, see your Windows documentation.
1. Turn on your PC.
2. Accessories, the HyperTerminal Folder, and click HyperTerminal.
3. At the Connection Description dialog, select an icon, enter a name for the connection to the
system, and click OK.
4. At the Connect To dialog, pull down the Connect using menu, select the COM port, and
click OK.