CANOGA PERKINS 9161 Network Interface Device - Manual (Page 37)

Using the Software 9161 Network Interface Device User’s Manual
Managing Security
25
3.4.5 Set Up Host Access
The SNMP agent allows access to up to 8 Host IP addresses. Set up and edit the Host informa-
tion for the 9161 at the Host Access Table screen. To access the Host Access Table, follow these
steps:
1. From the System menu type 4, Host Table/ SNMP Settings, and press <Enter>.
2. At the Host Access Table screen, type 2 to add a host, then at the prompt, enter the host
IP address and mask, or type 1 to edit a host. At the Add Host Access Entry screen, set
values for these parameters:
• Telnet Access: Allow (Yes) or disallow (No) Telnet
• FTP/TFTP: Select FTP, TFTP, Both, or None
• SNMP Access: Select Write (also allows Read access), Write, or None
• SNMP Protocol: Select V1V2cV3, V1V2c, or V3
• V1/V2c Read and Write Communities: Enter name of community, up to 11 charac-
ters
• V1/V2c Access Level: Select Supervisor, Operator, or Observer
3. To remove a host, type 3 , then follow the prompts.
4. To return to the System Menu, press <Esc>.
3.4.6 Set Up the Notification Destination for Traps
Use the Trap Notification/Destination Table to view and set up the destination for Trap messages.
In addition to setting the host address and port, you can set the security level for the notification,
then set values for various parameters, depending on the security level. For details on and val-
ues for security parameters for your system, see the documentation for your network security
system. To access and update the Trap Notification/Destination Table, follow these steps:
1. At the System menu, type 5 , Notification Settings, and press <Enter>. The Notification
Destination Table screen appears.
2. To edit an existing destination, type 1 and press <Enter>, use <Space> to toggle through
the hosts, and use <Enter> to select the destination you wish to edit.
3. On the Edit Notification Destination screen, select the number, 1 through 8, of the param-
eter(s) you want to change. When complete, press <Esc> to return to the Notification
Destination Table screen.
4. To add a destination, type 2 and press <Enter>, then type in an IP address and press
<Enter>. Enter the required values as follows:
a. Edit the IP Address you originally entered, if required, and press <Tab>.
b. Enter Trap Notification Port for the destination; Range is 1 to 65535; typically set to
162 and press <Tab>.