CANOGA PERKINS 9161 Network Interface Device - Manual (Page 31)

Using the Software 9161 Network Interface Device User’s Manual
Managing the 9161
19
• Management VLAN double Tagged: Enable or disable double tagging for the
VLAN
• Telnet Host Verification: Enable or disable checking whether host is listed in host
table; default is disabled, which allows access to all hosts
3. To return to the System menu, press <Esc>.
The SNMP agent allows access to up to 8 Host IP addresses. Set up and edit the Host informa-
tion for the 9161 at the Host Access Table screen. To access the Host Access Table, follow these
steps:
1. From the System menu type 4 , Host Table/ SNMP Settings, and press <Enter>.
2. At the Host Access Table screen, type 2 to add a host, then at the prompt, enter the host
IP address and mask, or type 1 to edit a host. At the Add Host Access Entry screen, set
values for these parameters:
• Telnet Access: Allow (Yes) or disallow (No) Telnet
• FTP/TFTP: (S)FTP/TFTP Access : Select None, (S)FTP, TFTP, orBoth
• SNMP Access: Select Write (also allows Read access), Write, or None
• SNMP Protocol: Select V1V2cV3, V1V2c, or V3
• V1/V2c Read and Write Communities: Enter name of community, up to 32 char-
acters
• V1/V2c Access Level: Select Supervisor, Operator, or Observer
3. To remove a host, type 3 , then follow the prompts.
4. To return to the System Menu, press <Esc>.
Traps are messages that require management attention and are routed to the Network Manager
and the 9161 Traps Log, but do not trigger alarms. Use the Trap Configuration screen to view
the current configuration and to enable or disable traps for the 9161. For a list of events that trig-
ger traps, see Table. To set up the traps, follow these steps:
1. From the System menu type 9, Trap Configuration, and press <Enter>.
2. At the Trap Configuration screen, type the number for a trap, then press <Space> to cycle
between Enabled or Disabled and press <Enter>
3. To return to the System menu, press <Esc>.